In the second step of the Stitching Wizard you choose one of four stitching methods. Usually you can select the stitching method based on how you took your pictures. The stitching methods are in two groups. The Сшивка фото / Photo stitching methods are used for true panoramic photos where the camera is in a single position and rotated between one picture and the next. The Сшивка документа / Document stitching method is used for stitching large documents that were scanned in sections on a flatbed scanner.
Полный автомат / Fully automatic (Сшивка фото / Photo stitching)
Select this stitching method if your camera's frontal tilt (pitch) is zero and
the lateral tilt (roll) is identical for all images. A small amount of lateral
tilt (up to 5 degrees) can usually be corrected automatically. This option
will give usually give excellent results if you have used a tripod and leveled
the camera properly. If you are not satisfied with the results from fully
automatic stitching, you may need to use semi-automatic or manual stitching
instead.
Полуавтомат / Semi-automatic (Сшивка фото / Photo stitching)
Select this stitching method if your camera was tilted up or down and the frontal
tilt (pitch) and lateral tilt (roll) are identical for all pictures. You'll
need to place stitching points on one or more pairs of images. The Panorama
Factory will determine the camera tilt angles and apply the same values to all
images. This option will usually give good results if your camera was mounted
on a tripod. If you cannot get satisfactory results with semi-automatic
stitching, you may need to use manual stitching instead.
Ручная / Manual (Сшивка фото / Photo stitching)
Select this stitching method for hand held images where the tilt angles may be
different for different images. You'll place stitching points on all pairs of
images so that The Panorama Factory can determine the individual tilt angles.
This method is the most general, but also the most time consuming for the user.
Ручная / Manual (Сшивка фото / Document stitching)
Select this stitching method for large documents that were scanned in sections
on a flatbed scanner. You'll place stitching points on all pairs of images so
that The Panorama Factory can rotate the individual images for the best match.
After selecting the stitching method, press the Следующий / Next> button to advance to the next step of the Wizard.
NOTE: Semi-automatic and manual stitching are available only through the Stitching Wizard. These stitching methods are not available through the Classic interface. Fortunately, you can start the Wizard from the Classic interface. To use semi-automatic or manual stitching from the Classic interface, select a group of thumbnails and use the Сшить с Мастером / Stitch with the Wizard command (Новое изображение / New image menu). This starts the Wizard with the selected images. You can use the full power of the Wizard, including semi-automatic or manual stitching, to create your panorama.