| Author |
Message |
    
Con Poulos
New member
Username: Conpan
Post Number: 1
Registered: 8-2004
| | Posted on Saturday, August 21, 2004 - 6:52 am: |   |
Hi,
Where do input resolution parameters in Panaroma Factory.
I would like to output Partial Pano's at 300Dpi.
Thanks
|
John Strait
Moderator
Username: Jstrait
Post Number: 112
Registered: 5-2001
| | Posted on Monday, August 23, 2004 - 6:20 pm: | |
To set the image resolution, you use the Image Properties dialog box. You can get to this dialog box two ways:
1. Double-click the image's thumbnail to make it the current image and then use the Properties command (Image menu).
--or--
2. Click the Image properties... button on the Save Image As dialog box.
If you want to control both image resolution and image size (e.g. 4 inches high at 300 dpi), you might need to resize the image. Otherwise setting the image resolution will determine the image size. For example, if your image is 900 pixels high, setting the image resolution to 300 dpi will cause the printed image height to be 3 inches (if you print at "actual size").
To control both image size and resolution, you might need to set the image size in pixels on Wizard step 5 or with the Resize command and then set the image resolution with the Image properties dialog box. |
matt mcclenathan
New member
Username: Panoguy7
Post Number: 1
Registered: 10-2009
| | Posted on Sunday, October 11, 2009 - 8:43 pm: | |
What is a good resolution to print a 30 inch wide print
www.stretchphotos.com
Under construction |
|
